|
|
Post by Starkindler (The Naked Jedi) on Nov 14, 2005 20:47:08 GMT -5
I had considered using two sink riser tubes (1.5" dia.) and connecting them with a piece I found in the Electrical section (maybe plumbing). It was a short, heavier tube (maybe 4") with three screws mounted into the casing (slightly raised) I keep thinking it would look good as the center of a double blade saber. Tha would be one of the easiest ways to do it I think. like this only with three screws:  |
|
Clone Commando
Message Board Member
May Your Swords Stay Sharp - Christopher Paolini
Posts: 464
|
Post by Clone Commando on Nov 14, 2005 20:56:43 GMT -5
hmm. thanks I'll try that
|
|
Solinbeb Newau
Message Board Member
There are many ways to learn the ways of the Force, but only those who have joined it may know best.
Posts: 1,181
|
Post by Solinbeb Newau on Nov 18, 2005 11:35:37 GMT -5
Yes, it's metal with the rubber sleeve over it.
I wasn't able to measure it (as it would look strange for me to do so while at work) but my guess would be about 1 1/4"
|
|
Clone Commando
Message Board Member
May Your Swords Stay Sharp - Christopher Paolini
Posts: 464
|
Post by Clone Commando on Nov 18, 2005 20:35:53 GMT -5
that's not that bad, I might look into it,
|
|
